Network configuration - ArchWiki - Arch Linux
DSA switch configuration from userspace Through DSA every port of a switch is handled like a normal linux Ethernet interface. The CPU port is the switch port connected to an Ethernet MAC chip. The corresponding linux Ethernet interface is called the master interface. All other corresponding linux interfaces are called slave interfaces. How to check your network connections on Linux It’s been used on systemd-based Linux systems for some time. The interface name depends on the physical location of the hardware. The " en " simply means "ethernet" just like "eth" does for eth0. LACP bonding and Linux configuration - Rackspace ~]# cat /proc/net/bonding/bond0 Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011) Bonding Mode: IEEE 802.3ad Dynamic link aggregation Transmit Hash Policy: layer2+3 (2) MII Status: up MII Polling Interval (ms): 100 Up Delay (ms): 0 Down Delay (ms): 0 802.3ad info LACP rate: fast Min links: 0 Aggregator selection policy (ad_select): stable Active Aggregator Info: Aggregator ID: 1 Number Configuring Ethernet interfaces by using the command line
To enable wireless support in Linux, the IEEE 802.11 network configuration option must be enabled (802.11 is the number of the wireless specification that all these devices follow.) Networking [*] Networking support [*] Generic IEEE 802.11 Networking Stack
Through DSA every port of a switch is handled like a normal linux Ethernet interface. The CPU port is the switch port connected to an Ethernet MAC chip. The corresponding linux Ethernet interface is called the master interface. All other corresponding linux interfaces are called slave interfaces. The slave interfaces depend on the master interface. It’s been used on systemd-based Linux systems for some time. The interface name depends on the physical location of the hardware. The " en " simply means "ethernet" just like "eth" does for eth0.
How To Configure Static And Dynamic IP Address In Arch Linux
NetworkConfiguration - Debian Wiki The configuration file resolv.conf at /etc/resolv.conf contains information that allows a computer connected to a network to resolve names into addresses. (Note: Do not confuse this configuration file with the program resolvconf, which unfortunately has a nearly identical name.) Linux Ethernet−Howto - Linux Documentation Project Table of Contents Linux Ethernet−Howto NS8390, DP8390, DP83905 etc..49